Tevo Tarantula Extensions: 3D Touch Bed Leveling Sensor

ESP32 Development Board WiFi+Bluetooth Ultra-Low Power Consumption Dual Cores ESP-32 ESP-32S Board
Integrated antenna and RF balun, power amplifier, low-noise amplifiers, filters, and power management module. The entire solution takes up the least amount of printed circuit board area. This board is used with 2.4 GHz dual-mode Wi-Fi and Bluetooth chips by TSMC 40nm low power technology, power and RF properties best, which is safe, reliable, and scalable to a variety of applications.

I’m constantly adding new features to my Tevo Tarantula printer. The latest addition is a bed leveling sensor.

It improves the quality of the prints a lot and in addition you don’t have to adjust the print bed manually every time. If properly configured it runs a measurement sequence of several points (3×3 in my case) before every print and uses this information to compensate during the print.

Where to buy?

You can find it in many places. I bought it here (Banggood)

Posted by squix78

Leave a Reply